AAEON EPIC-CV01 Series - Manual (Page 25)

2-17 Chapter 2: Motherboard information
8. Serial ATA 3Gb/s connectors (7-pin SATA3G_1/2])
These connectors connect to Serial ATA 3Gb/s hard disk drives and optical
drives via Serial ATA 3Gb/s signal cables.
NOTES:
• These connectors are set to [IDE] by default. In IDE mode, you can connect
Serial ATA boot/data hard disk drives to these connectors.
• You must install Windows ® XP Service Pack 3 or later version before using
Serial ATA hard disk drives.
• When using hot-plug and NCQ, set the Configure SATA as item in the
BIOS to [AHCI]. See section 3.4.2 IDE Configuration for details.
SATA3G_1
SATA3G_2
GND RSATA_RXP1 RSATA_RXN1 GND RSATA_TXN1 RSATA_TXP1 GND
GND
RSATA_TXP2 RSATA_TXN2
GND
RSATA_RXN2 RSATA_RXP2
GND
EPC-CV1 Series SATA 3.0Gb/s connectors
9. SATA power connector (4-pin SATA_PWR1)
This connector is for the SATA power cable. The power cable plug is
designed to fit this connector in only one orientation. Find the proper
orientation and push down firmly until the connector completely fit.
+5V
GND
GND
+12V
SATA_PWR1
EPC-CV1 Series SATA power connector