AAEON AQ7-IMX6 - Manual (Page 14)

Q s e v e n M o d u l e A Q 7 - I M X 6
Chapter 2 Quick Installation Guide 2-3
2.2 Location and Mechanical Drawing of Connectors and Jumpers
Component Side Solder Side
2.3 List of Jumpers
The board has a number of jumpers/Connectors that allow you to
configure your system to suit your application.
The table below shows the function of each of the board's jumpers:
Label Function
SW1 Boot Mode Selection
SW2 Boot Selection
2.4 Boot Mode Selection (SW1)
Program mode Internal Boot mode(Default)