AAEON ACP-1103 - Manual (Page 90)

M u l t i - T o u c h P a n e l P C A C P - 1 1 0 3
Appendix A Programming the Watchdog Timer A-4
// This procudure will enable the WDT counting.
AaeonWDTEnable();
}
**************************************************************************
**************************************************************************
// Procedure : AaeonWDTEnable
VOID AaeonWDTEnable () {
WDTEnableDisable(1);
}
// Procedure : AaeonWDTConfig
VOID AaeonWDTConfig (byte Counter, BOOLEAN Unit) {
// Disable WDT counting
WDTEnableDisable( 0 );
// Clear Watchdog Timeout Status
WDTClearTimeoutStatus();
// WDT relative parameter setting
WDTParameterSetting(Timer, Unit);
}
VOID
WDTEnableDisable(byte Value) {
If (Value == 1)
WDTSetBit( TimerReg, EnableBit, 1 );
else
WDTSetBit( TimerReg, EnableBit, 0 );
}
VOID
WDTParameterSetting(byte Counter, BOOLEAN Unit) {
// Watchdog Timer counter setting
WDTWriteByte( CounterReg, Counter );
// WDT counting unit setting
WDTSetBit( TimerReg, UnitBit, Unit );
// WDT output mode set to pulse
WDTSetBit( TimerReg, ModeBit, ModeVal );
// WDT output mode set to active low
WDTSetBit( TimerReg, PolarityBit, PolarityVal );