AAEON AEC-204 - Manual (Page 12)

W a l l m o u n t C h a s s i s A E C - 2 0 4
Chapter 2 Quick Installation Guide 2- 12
Step 4: Replace the whole unit back to the Chassis
Step 5: You may choose the attached parallel port and serial port
I/O connectors. Simply brace the connector to the
specified slot location with the provided screws. Then
connector one end to the CD-ROM /FDD drive and the
other end to the CPU board through accessory board
Note: Don’t forget to attach the face plate to the opening slot in
the front of the chassis