Alpha Technologies UPE-8 - Manual (Page 10)

745-179-C0-001 Rev. A
10
2. Installation
2.4 Louver Filter Installation Procedure
1. Unlock and remove the front door, if installed.
2. From the inside, remove the three wing-nuts holding the lid onto
the enclosure, remove the lid and set aside.
3. Remove the protective paper from the adhesive strips on item 2,
and press into place on the back inside wall of the enclosure.
Ensure all louvers are covered.
4. Fold item 7 so that the right side (as seen from the front of the
enclosure) is 12.1 inches long, and the left side is 6.5 inches long.
5. Remove the protective paper from the adhesive strip on item 7,
and press into place on the front inside wall of the enclosure.
Ensure all louvers on the front and sides are covered.
6. Replace the lid, reinstall and tighten the wing-nuts.
7. Replace and lock the front door.
2
6.5"
12.1"
7
CAUTION
Do not expose power supply and
electrical boxes to moisture while lid is
removed
Fig. 5 Louver Filter Placement