Installation instructions – Kaiser EA64.. User Manual
Page 6
6
INSTALLATION INSTRUCTIONS
Two persons are required for proper installation. A
qualified installer should be commissioned to make the
mounting.
There are two ways of installation of the cooker hood:
on the wall and under a wall unit.
•
Trace a vertical line on the wall to indicate the
centre of the cooker plate.
Place the hood body
on the wall to get min 650
mm from the cooker plate (see p. 1 ). Level it
horizontally. Use the bottom of the rear side of the
hood as ruler to trace the line.
•
Measure a distance between the hood’s bottom
and the top holes . Trace a horizontal line on the
wall on the same distance above the bottom line.
Mark the mounting holes on the wall: 496 mm
between the holes or 248 mm between each hole
and the central line.
•
Drill the holes using a drill of Ø 8 mm, drive the
plugs in and then tight the screws.
•
Drill the holes
under 90 mm of the top holes .
Drive the plugs.
•
Hang the cooker hood
on the screws .
•
Tight the screws in the holes , operate from the
inside of the cooker hood.
•
Mount the V-flap
on the exhaust outlet of the
cooker hood .
•
Drill in the wall unit the four holes
in predefined
places using a drill of Ø 4 mm.
•
Mount the V-flap
on the exhaust outlet of the
cooker hood .
•
Fasten the cooker hood with a four screws,
operate from the inside of the wall unit.
•
For an air extractor mode of the cooker hood
make an opening
in the bottom of the wall unit in
advance, in accordance with the drawing.
•
To close possible space between the cooker hood
and the wall, use a plastic spacing bar .
•
f the cooker hood will be operate in odour
absorber mode it is necessary to install charcoal
filter ( see p. 22).
MOUNTING OF A COOKER HOOD WITH
ELECTRONIC CONTROL
M
M
ounting on the wall
ounting under a wall unit
1
2
1
2
3
4
8
•
4
3
2
5
6
4
5
7
I
4
5
1
8
516
254
4
3
1
5
496
90
2
7
6
6
EN