Atec Agilent-E8361A - Manual (Page 29)

9
E8361A
Corrected system performance with 2.4 mm connectors
Description Specification (dB)
10 to 200 MHz 1 200 MHz to 2 GHz 2 to 20 GHz 20 to 40 GHz 40 to 50 GHz
Directivity  55 9  1
Source match 5 6  5 0
Load match   1 7 6
Reflection tracking ±0.050 (+0.0/°C) ±0.00 (+0.0/°C) ±0.00 (+0.0/°C) ±0.060 (+0.0/°C) ±0.080 (+0.0/°C)
Transmission tracking ±0.100 (+0.0/°C) ±0.059 (+0.0/°C) ±0.079 (+0.0/°C) ±0.110 (+0.0/°C) ±0.15 (+0.0/°C)
Transmission uncertainty (specifications)
Reflection uncertainty (specifications)
Magnitude
0.01
0.1
1
10
-90 -80 -70 -60 -50 -0 -0 -0 -10 0 10
Transmission coefficient (dB)
E861A full two port cal using N69A
00 MHz to  GHz
 to 0 GHz
0 to 0 GHz
0 to 50 GHz
S11 = S = 0
Source power = -15 dBm
Un
ce
rta
in
ty
(d
B)
Phase
0.1
1
10
100
-90 -80 -70 -60 -50 -0 -0 -0 -10 0 10
Transmission coefficient (dB)
E861A full two port cal using N69A
00 MHz to  GHz
 to 0 GHz
0 to 0 GHz
0 to 50 GHz
S11 = S = 0
Source power = -15 dBm
Un
ce
rta
in
ty
(d
eg
re
es
)
Magnitude
0
0.01
0.0
0.0
0.0
0.05
0 0. 0. 0.6 0.8 1
Reflection coefficient (linear)
E861A with N69A
00 MHz to  GHz
 to 0 GHz
0 to 0 GHz
0 to 50 GHz
S1 = S1 = 0
Source power = -15 dBm
Un
ce
rta
in
ty
(l
in
ea
r)
Phase
0


6
8
10
0 0. 0. 0.6 0.8 1
Reflection coefficient (linear)
E861A with N69A
00 MHz to  GHz
 to 0 GHz
0 to 0 GHz
0 to 50 GHz
S1 = S1 = 0
Source power = -15 dBm
Un
ce
rta
in
ty
(d
eg
re
es
)
Standard configuration and standard power range (E8361A)
Applies to E8361A PNA Series analyzer, N4693A
(2.4 mm) ECal electronic calibration module, 85133F
flexible test port cable set, and a full two-port
calibration. (Specifications apply over environmental
temperature of 23 °C ±3 °C, with less than 1 °C
deviation from calibration temperature.)
1. Typical performance.
1. Configurable Test Set, Extended Power Range and Bias-Tees, Receiver Attenuators, Frequency Offset Mode,
and Reference Channel Transfer Switch (Option 01, UNL, 016, 080 and 081).