Atec Agilent-Infiniium-9000 Series - Manual (Page 12)

12
Infiniium 9000 Series applications and upgrades
PrecisionProbe software (N2808A)
Make more accurate measurements independent of what probes or cables used. Agilent’s
N2808A PrecisionProbe software characterizes and corrects for the loss in your speciic cable or
probe. PrecisionProbe removes the uncertainty about the input connected to your oscilloscope by
allowing you to see its characteristics in less than ive minute. PrecisionProbe gives you design
and debug conidence by allowing you to quickly de-embed probe and cable loss to make more
accurate measurements.
For more information: www.agilent.com/find/PrecisionProbe
Quickly characterize and correct for any
input to your oscilloscope
Power application (U1882A or Option 015 on new scope purchases)
Agilent’s power application provides a full suite of power measurements. Make more accurate
power-supply eficiency measurements by using an U1880A de-skew ixture to de-skew your volt-
age and current probes.
This application is supported on all models.
For more information: www.agilent.com/find/9000_power-app
Use your scope to quickly make and analyze
power measurements.
FPGA dynamic probe application (N5397A or Option 016 on new scope purchases)
Agilent’s MSO FPGA dynamic probe provides internal FPGA visibility and quick instrument
setup using an innovative core-assisted debug approach. Measurement tasks that previously
took hours can be done in seconds with a few mouse clicks.
This application is supported on all MSO models.
For more information: www.agilent.com/find/9000_xilin x
Rapid FPGA debug.
InfiniiView Oscilloscope Analysis Software (N8900A)
Wish you could do additional signal viewing, analysis and documentation tasks away from
your scope and target system? With Agilent’s IniniiView oscilloscope analysis software
you can. Capture waveforms on your scope, save to a ile, and open the data record into
Agilent’s IniniiView application. View, analyze, share, and document scope measurements
anywhere your PC goes.
User-definable application (N5467A or Option 040 on new scope purchases)
Rapidly develop your own automated measurements and tests. This application provides the
framework you need to quickly program and automate any single or set of measurements the
oscilloscope can make.
The application also provides full control of other Agilent instruments and HTML reporting capabilities.
For more information: www.agilent.com/find/9000_UDA
Quickly automate oscilloscope measurements.