Autel Maxivideo MV208 - Manual (Page 12)

10
√ To install the batteries, remove the battery compartment and
insert four (4) new AA batteries into the proper slots in the
battery compartment.
4) Proper battery orientation is indicated in the battery compartment.
5) Replace the battery compartment and screw using a screwdriver
to close the battery compartment cap.
3.2 Battery Precautions
 Remove the battery while cleaning the tool.
 Remove the battery before storing the tool for a long period of
time to prevent battery leakage from damaging battery
compartment.
 When necessary, replace all four (4) batteries with new ones.
 Use only the size and type of batteries specified.
 Be sure to install the batteries with the correct polarity as
indicated in the battery compartment.
 Properly dispose of batteries. Exposure to high temperature can
cause batteries to explode. Do not dispose in the fire.
3.3 The Imager Head and Cable Installation
To use the tool, the imager head and cable must be connected to the
display unit. To connect the cable to the display unit, make sure the
key and slot (Fig.7) are properly aligned. Once they are aligned,
finger-tighten the knurled knob to hold the connection firmly in
place.
Fig. 7