Autel Maxivideo MV208 - Manual (Page 18)

16
readable. Do not operate the tool without the caution label.
 Turn on the power and make sure the tool model through the
splash screen and then display the live screen.
 If the tool does not work well after being turned on, please have
the tool checked by a qualified technician. Any tool that cannot
be controlled with the power button is dangerous and must be
repaired.
2
NOTE: Please check following methods to avoid injury.
 FOR WALLS:
For inspecting the inside walls, be sure to shut
off the circuit breaker to the whole house before using the tool.
 FOR PIPES:
If you suspect a metal pipe could contain an
electric charge, have a qualified electrician to check the pipe
before using.

2
FOR AUTOMOBILES: Be sure the automobile is not running
during inspection. Metal and liquid under the hood may be hot.
Don’t get oil or gas on the imager head.
4.4 Tool and Work Area Set-Up
Set up the tool and work area according to these procedures to
reduce the risk of injury from electric shock, entanglement, and
other causes and prevent tool damage.
1) Check work area for:
 Sufficient lighting.
 Do not work in area until flammable sources have been
identified and corrected. The tool is not explosion proof
and can cause sparks.
 Do not use the tool while standing in water.
2) Check the area and determine if MaxiVideo
TM
MV208 Digital
Inspection Videoscope is the correct tool for the job.
 Check the access points to the area.
 Check if there is any electric power supplied to the area to
be inspected.
 Check if the any liquids will be occurred during the