Avision AV3200SU (300500001/300500002) User Manual
Page 18
2-10
2.8 Connecting the Cable
i).
Turning the Power Off
Depress the side marked “O” to turn the power off.
Connect the power cable and SCSI signal cable as shown
in Figure 2-7.
ii).
Turning the Power On
Depress the side marked “I” to turn the power on. The
POWER LED will light. If not, please check the power
source.
iii).
SCSI Termination/USB Port
The scanner is designed with both the USB and SCSI port.
If you wish to connect the scanner with a USB port, please
install the scanner driver first and then connect the USB
cable. If you wish to connect the scanner with SCSI port,
please note the following:
The scanner comes complete with a built in SCSI
terminator. If the scanner is the last device in a SCSI
chain, the terminator should be switched on. If the
scanner is not the last device, the terminator should be
off. The terminator on/off switch is located on the back of
the scanner, to the left of the SCSI cable connectors.