Avlex ACT-80T Wideband Digital Bodypack Transmitter - Manual (Page 16)

Battery Removal and Installation
! Pushing down both snap locks on the sides to
open battery compartment cover. Take out the
two batteries. (Figure 3)
! Insert two fresh AA batteries (alkaline type is
recommended) into the battery compartment
according to the correct polarity (- and +) as
shown in (Figure 4). Then close the battery
compartment cover tightly.
Caution:
Remove the batteries if unused for a long period
of time to prevent battery leakage, corrosion and
causes possible damage to electronics.
(Figure 4) (Figure 3)
Digital Bodypack Transmitter Digital Bodypack Transmitter
28 27
Disassemble the Belt Clip
! Turn the bodypack transmitter
to the back side like the right
diagram.
! Pull open one side of the belt
clip and make it depart from
the slot of the bodypack
transmitter like the right
diagram.
! Then the other side of the belt
clip can be departed from the
other slot easily. The whole
belt clip is departed from the
bodypack transmitter
completely like the right
diagram.