Baldwin Wesley Handleset with Carnaby Knob - Manual

TEMPLATE PLANTILLA
Handlesets Installation Instructions
1. Adjust and install latches
Measure your door and prepare using template if needed.
MEASURE
BACKSET
5 1/2”
2. Install trim
3. Install knob / lever
Place lever or knob onto assembly and tighten set screw to secure.
4. Install and adjust strike
Latch
If backset of door measures 2-3/4”
(70mm), adjust latch shown by
grasping the spring pin and moving
it to the 2-3/4” slot.
Install latch with 11/16” screws.
Make sure the slant of the latch bolt
faces in the direction that the door
closes.
Deadbolt
If backset of door
measures 2 3/4”
(70mm), adjust
latch by rotating
face as shown.
Install latch with
11/16” screws.
Ensure the latch is
inserted with the word
“UP” on top.
Note, for a 1-1/2” (38mm) diameter hole,
test if latch extends and retracts. Chisel
out area if required.
Adjust tang as needed. 1/8” pilot holes may be required.
See drilling template
for hole location.
Prestige Series
www.baldwinprestige.com
Make sure the curve of half round spindle
corresponds to the opening in the latch; if
it does not, reverse the handing as follows:
(1) Pull spindle away from mechanism, (2)
rotate it 1/2” turn (180°) and release.
Spindle