BlueBird SC550A_968999351 - Manual (Page 19)

19
SET-UP
6. Using a 9/16” wrench and socket wrench,
remove top bolt and lock nut on the depth of
cut handle. Loosen lower bolt. Rotate handle
up and replace bolt in lower hole and tighten
hardware. See Figure 4.
7. Place knob into selected depth of cut hole and
secure tightly. See Figure 5.
8. Fill engine and centrifugal clutch case with oil.
See engine manual for quantity and viscosity
rating.
9. Fill engine with fuel. See engine manual for
fuel recommendation.
10. See section in this manual on starting engine
then drive the unit off of the pallet.
1
2
1. Remove Bolt
2. Loosen but do not remove
Depth Control Knob
FIGURE 4
FIGURE 5
IMPORTANT INFORMATION
Neither the engine nor the centrifugal
clutch cases are shipped with oil.
Fill engine and clutch case with oil before
starting the engine.