Borg Locks BL 5001 Series - Manual (Page 2)

If y u o have encountered any problems then
please refer to the trouble shooting g uide, if this
doesn t help to solve your problem contact the
Borg helpline for further information and
assistance.
Tte lock is pre-set for right hand door. When
changing to a left hand door, please make sure the
following procedure is also carried out on the back
plate to prevent over-rotating of the inside handle.
INSTALLATION
PRIOR TO INSTALLATION
HANDING CHART
CHANGING TO A LEFT HAND HUNG
DOOR
INSIDE HANDLE
DIA.4
Please check the 5000 series lock is working
correctly, by entering the code as stated on the
printed code card (remembering to press“C”first
). Then rotate the handle clockwise, after rotating
0 approximately 45 you will h ear a n audible click as
the tumblers engage. The handle should then return
freely to the horizontal position.
(Always take hand from outside)
Hand of door
L
Hand of door
left hand( H)
( LHR )
Hand of door
left hand reverse
Hand of door
right hand reverse
( RHR )
N. B. All units are set at the factory to suit right
hand hung doors
To change this unit to suit a left hand hung door
please follow the instructions below:
1. Remove the rubber grommet from the base of
the handle to expose the grub screw.
2. With the hexagonal key provided, remove the
grub screw that holds the handle in place.
O 3. Now you can lift handle and turn it 180 off the
slide the handle back into position and refit the
grub screw and grommet.
4. Remove the 4 small screws that hold the spring
cassette to the handle.
5. Rotate the handle 180°
6. Ensure that the spring is located between the lugs
of the cassette and the lugs of housing.
7. Replace the 4 screws ( to ensure that the screws
do not work loose during operation we
recommend you use a mild adhesive) .
DIA.1 DIA.2 DIA.3
1
2
ESTABLISH THE HAND OF THE DOOR
Viewing from the OUTSIDE it is right hand if the
e hinges are fitted on th right and it is left hand if the
t hinges are fit ed on the left hand side of the door.
This is regardless of whether the door swings inward
or outward.
1. With the back side of the backplate facing you,
2 remove the cover ( ) by unscrewing the 4
screws ( 1 ). ( DIA.1 )
as in ( DIA.1 )
3. Fit the RING back as in ( DIA .4 )
4. Make sure the cover ( 3 ) is secured back in place
screws. by the 4
2. Lift THE RING( 3 ) up and re position THERING