Brickcom OSD-040 36x Series - Manual (Page 33)

29
Chapter 6 - Accessing the Network Camera
6.1 Check Network Settings
The camera can be connected either before or immediately after the software
installation. The Administrator should complete the network settings on the
configuration page, including entering the correct subnet mask and IP address of
gateway and DNS. Ask the network administrator or Internet service provider for the
detail information.
6.2 Add Password to Prevent Unauthorized Access
The Administrator should immediately implement a new password as a matter
of prudent security practice. For first time use, the user name and password for
the Administrator are assigned as “admin/admin”. After the Administrator changes
the Administrator password, the web browser will display an authentication window
to confirm the new password. Once the password is set, there is no provision
to recover the Administrator’s password. If the Administrator’s password is
lost, the only option is to restore the original factory default settings.
The Administrator can set up a maximum of ten (10) user accounts. Users will be
able to access the Network Camera, but will not be allowed to access system
configurations.