BVA Hydraulics IEPD5513, IEP10010, IAP10010, IEPD10010, IEPDS10010 - Manual (Page 2)

SAFETY AND GENERAL INFORMATION
Save these instructions. For your safety, read and understand the information contained within. The owner and operator shall
have an understanding of this product and safe operating procedures before attempting to use this product. Instructions and
safety information shall be conveyed in operator’s native language before use of this product is authorized. Make certain that the
operator thoroughly understands the inherent dangers associated with the use and misuse of the product. If any doubt exists as
to the safe and proper use of this product as outlined in this factory authorized manual, remove from service immediately.
Inspect before each use. Do not use if broken, bent, cracked or otherwise damaged parts are noted. If any component of this
product has been or suspected to have been subjected to a shock load (a load dropped suddenly, unexpectedly upon it), discontinue
use until checked out by a BVA Hydraulics Authorized Service Center. Owners and operators of this equipment shall be aware
that the use and subsequent repair of this equipment may require special training and knowledge. It is recommended that an
annual inspection be done by qualified personnel and that any missing or damaged parts, decals, warning / safety labels or signs
be replaced with factory authorized replacement parts only. Any component of this Equipment that appears to be damaged in any
way, is worn or operates abnormally shall be removed from service immediately until such time as it can be repaired/replaced.
Labels and Instruction Manuals are available from manufacturer.
PRODUCT DESCRIPTION
BVA Hydraulics Shop presses are designed for automotive, truck, implement, fleet, and industrial repair shops where pressing,
bending, straightening, forming, holding is required. Each press includes a cylinder, an electric pump with pendant switch, a
winch assembly which provides safe and fast way to raise and lower the bed frame, and a pressure gauge which provides for
monitoring the applied press force.
Typical applications include installation and removal of alternator and power steering pump bearings, axle bearings, transmission
bearings, seal, driveshaft bearings and u-joints and others. It is not intended for use as an assembly table or as fixture stand used
to secure a large, final assembly component. Please refer to Cylinder and Pump manuals for more information.
WARNING: To reduce the risk of personal injury and/or property damage, ensure that the rated working pressure of
each pressurized attachment be equal to or greater than the rated working pressure developed by the hydraulic pump.
NOTICE: The power retract feature of the IEPD5513, IEPD10010 & IEPDS10010 Shop Presses is not intended to be used
under load. Never pull or raise a workpiece with the power retract feature.
Cylinder:
2
BEFORE USE
1. Inspect before each use. Do not use if bent, broken or cracked components are noted. Check for and tighten any loose as-
semblies.
2. Verify that the product and the application are compatible, if in doubt call BVA Technical Service.
3. Before using this product, read the operator’s manual completely and familiarize yourself thoroughly with the product, its com-
ponents and recognize the potential hazards associated with its use.
• Study, understand, and follow all instructions provided with and on this device before use.
• Do not exceed rated capacity.
• Prior to use, make sure press is securely anchored.
• The press shall be installed and operated in accordance with federal (OSHA), state and local safety standards.
• Operators and observers shall wear eye protection that meets ANSI Z87.1 and OSHA standards.
• Keep hands, arms, feet and legs out of the work area. Accidental slippage can result in personal injury.
• Use appropriate guarding to contain any pieces that may break or fly apart when applying force.
• Use only press accessories having a capacity rating equal to or greater than the capacity of the press.
• Verify lift cables are slack before pressing on the bolster.
• Avoid off-center loads.
• No alterations shall be made to the product.
• Failure to heed and understand these instructions and markings may result in personal injury, property dam-
age or both.
! WARNING
!