BVA Hydraulics IEPD5513, IEP10010, IAP10010, IEPD10010, IEPDS10010 - Manual (Page 5)

5
ASSEMBLY
1. Ensure bed frame at lowest position and winch cable is slack.
2. Install the winch assembly to the press using 3 bolts, washers and nuts (ref. Figs 2 & 3).
3. Secure cylinder to cylinder adapter plate, and mount the adapter plate to upper cross member using 4 bolts and washers.
NOTICE: The cylinder comes with carrying handles, simply loosen the Allen head socket screw to remove the handles.
4. Attach base sections to upright channels with 4 bolts and nuts.
5. Attach lower cross member to upright channels with 4 bolts and nuts.
6. For 55 Ton Models only: adjust the pump bracket to desired height and secure with bolts, nuts & washers provided.
7. Connect pressure gauge and hydraulic hose to the gauge adapter, then connect the gauge adapter to pump.
8. For Models IEPD5513, IEPD10010 & IEPDS10010 only: Attach second hose to Port B on Control Valve. Attach second coupler
to free hose end. Connect coupler to bottom port on Cylinder.
NOTICE: Ensure thread tape or compound is used on connections.
8. Place the pump on the pump bracket and connect the other end of hydraulic hose to cylinder.
CAUTION: Before disassembling, slide bed frame section down to its lowest position.
OPERATION
WARNING: Shop presses can present a projectile hazard. Ensure workpiece is center loaded and secure. Reduce
risk of flying debris by following all operating instructions. Know your press and hazards associated with its use.
Keep hands and feet from bed area at all times.
WARNING: Risk of serious eye injury from projected or blown debris. Reduce risk by wearing safety goggles when working
with or around press.
1. Insert the support pins to desired height, then lower the bed frame using the winch until the cable is slack and the bed frame
is resting fully on the support pins.
2. Place arbor plates on the bed frame (optional).
3. Place workpiece on bed frame, using every precaution necessary to ensure your safety and prevent property damage.
4. Operate the pump:
a) For Model IMP5506 (manual): Close the release valve by turning it clockwise, and pump the handle to extend the cylinder
ram. To retract, simply open the release valve of pump.
b) For Models IAP5506, IAP5513 & IAP10010 (air): Connect to suitable air supply, press on the foot pedal to extend the
cylinder ram. To retract, simply press the release valve by stepping on the raised, stirrup shaped portion of the foot pedal.
c) For Models IEP5506, IEP55513, IEPD5513, IEP10010, IEPD10010 & IEPDS10010 (electric): Toggle the ON/OFF switch
to start the electric pump and let the pump idle for a few minutes before putting into operation. Use control valve knob to
extend or retract the cylinder ram.
WARNING: Burst hazard exists if hose or connection pressure exceeds rated pressure. Always monitor the pressure
gauge while in operation and never leave loaded press unattended.
NOTICE: The power retract feature of the IEPD5513, IEPD10010 & IEPDS10010 Shop Presses is not intended to be used
under load. Never pull or raise a workpiece with the power retract feature.
NOTICE: Never operate pump with hose disconnected from cylinder. If operated in this condition, the hydraulic hose and con-
nections become pressurized. This increases burst hazard.
5. Apply load to workpiece. Do not overload the workpiece.
6. Stabilize workpiece in a manner which will not allow it to inadvertently fall from the bed once the load is removed.
7. Once cylinder has fully retracted, remove workpiece.
NOTICE: To protect your cylinder, do not continue to operate pump after cylinder plunger is fully extended or retracted.
!
!
!