AmeriHome QTPOP Table Top Popcorn Maker - Manual (Page 5)

QTPOP Electric Tabletop Popcorn Popper
5
POPPING INSTRUCTIONS
DO NOT TOUCH THE KETTLE WITH YOUR BARE HANDS!
While in operation, the kettle will become hot enough to burn your skin.
Do not attempt to pop popcorn kernels in the kettle without oil.
Cooking with hot oil can be dangerous.
Do not leave the Popcorn Popper unattended. Do not allow
children to use Popcorn Popper without adult supervision.
The Popcorn Popper has two switches on the top of the unit.
The switch on the left controls the light by turning it on and off.
The switch on the right, the “pop” switch, activates the motor
and the heater in the kettle (Fig. 3).
Set the tray in the bottom of the Popcorn Popper.
Add 1 Tablespoon of oil into the kettle by lifting the small tab on
kettle lid (Fig.4). You may use vegetable, canola, corn, peanut or
coconut oil.
Turn on both switches on top of the Popcorn Popper.
Allow the kettle to preheat the oil for 2-3 minutes.
Turn the “pop” switch off momentarily while you add 1/3 cup of
popcorn kernels. Close the kettle lid and turn the “pop” switch
back on. Close the door on the front of the Popcorn Popper.
In roughly 2 minutes, you will hear the popcorn begin to pop,
and begin to spill out of the kettle into the tray. When you no longer
hear any kernels popping, turn off the “pop” switch. Open the door
to the Popcorn Popper, and use the handle on the side of the kettle
to pour out any popcorn that has remained in the kettle (Fig. 5).
If making more than one batch of popcorn, turn the “pop” switch off to allow the unit to cool for 5 –10
minutes between batches to keep the kettle from overheating.
Fig. 3
Light
Switch
“Pop”
Switch
Fig. 4
Fig. 5