BARSKA BE11638 Pro Edition Metal Detector - Manual (Page 5)

5
PREPARATION
ASSEMBLING THE DETECTOR
Assembling the detector is easy and requires no special tools. Just follow
these steps.
1. Unscrew the knobs on the search coil and remove the knobs and
the connector. Insert the smaller stem and align the holes on the
search coil bracket and the stem. Push the connector through the
holes, then replace and tighten the knobs.
2. Loosen the stem’s lock nut (connected
with the handle) in the direction of the
arrow. Then insert the smaller stem into
the big stem connected with the handle.
Turn the stem’s lock nut in the reverse
direction of the arrow to lock it in place.
3. Insert the latch on the top of the handle into the assembly hole on
the bottom of the control box. Then slightly push the control box in the
direction of IN on the handle to fix the latch in place.
4. Tighten the fixing screw.
5. Insert the search coil cable plug into the five pin
jack on the front control box’s housing.
Lock Nut
Assembly Hole
Fixing Screw
Latch
Control Box