BARSKA BE11638 Pro Edition Metal Detector - Manual (Page 6)

6
6. Lengthen or shorten the stem, so when you stand upright with the
detector in your hand, the search coil is level with and about .5~2
inches / 1~5cm above the ground. After that tighten the lock nut.
Caution:
• The search coil cable plug fits into the connector only one way.
DO NOT force the plug or you could damage it.
• DO NOT disassemble the stem lock nut.
In case you disassemble it, place the
washer on the top of the stem
connected with the handle with the
small head of the washer upwards.
Then hitch the stem lock nut on the
washer then tighten it to lock it in place.
ADJUSTING THE SEARCH COIL
Loosen the knobs at the search coil’s end, adjust the search coil to the
desired angle. (The search coil should be parallel with the ground.)
Tighten the knobs just enough to keep the search coil from rotating or
wobbling.
INSTALLING BATTERY
You need two 9V alkaline batteries to power your detector.
1. If the detector is on, turn the power switch (on the
control panel) to POWER OFF.
2. Press on the battery compartment cover and slide
the cover off in the direction of the arrow.
Small head
O PE N