I-View CTX-104PVAD Multi-signals Transmission System - Manual (Page 2)

2
1.) Front panel screws: These screws are for fixing front panel and RPM-319 (19” rack mounting panel).
2.) LED Power indicator: To indicate the status power-on or power-off of CRX-104PVAD. The status of
LED is --- LED on: Normal, LED flash: Power is not enough, LED Off: No power.
3.) LED Data indicator: To indicate the status video and RS-485/422. The status of LED is --- LED on:
Normal, LED flash: Transmission error.
4.) Terminal blocks: To connect PTZ controller; the electrodes of the “+” and “-“ need to be matched
correctly with the electrodes of the PTZ controller (e.g. + to (+) RS485/422 and - to (-) RS485/422).
5.) RF in/ AC out (F connector): Provide video/audio/data signal input and AC80V power output.
6.) Audio out (BNC connector): To transmit output audio signal to DVR or Monitor.
7.) Video out (BNC connector): To transmit the output video signal to DVR or Monitor.
8.) Surge protector: Connect to the earth-ground by shorter than 10 feet 16AWG or thicker cable.
9.) Power plug: AC 100V-110V or AC 220V-240V power input.
10.) Fuse plug: To protect the device when power is short or overloading.
11.) Power switcher: To turn on /off power.
19” Rack Mount installation
Rack mounting (RMP-319, 19” rack mount panel) for three of CRX-104PVAD models
CRX-104PVAD
RMP-319
--CRX-104PVAD--
1
2
3
Back Panel
4 5 6 7
8 9 10 11