PA Industries Advantage Servo Roll Feed SRF-5/8/12/16/20/24/28/32/36 - Operation Manual - Manual (Page 16)

ULTRA ADVANTAGE SERVO ROLL FEED 2 /14/2003
16
Bandwidth is a tuning parameter, before changing its value consult the P/A Industries Service Department
Kp Multiplier is a parameter that defines a proportional gain of the position loop of the Strip Encoder and based on the
value of the motor encoder's Kp proportional gain. This is a tuning parameter, before changing its value, consult the
P/A Industries Service Department.
NOTE: To exit setup editing at any time, press the “OPER” key. Changes will be saved.
4 HOW TO …
4.1 HOW TO CREATE A NEW TOOL
NOTE: Make sure that the PROGRAMMING “LOCKED / UNLOCKED” key switch is in “Unlocked”
position and OPERATOR screen is displayed. If the current screen is not OPERATOR one then press the
“OPER” key to bring it up.
Press the “TOOLS” key.
Position the pointer next to Create new tool command and press the “ENTER” key.
E d i t T o o l
A c t i v a t e T o o l
C r e a t e N e w <
P r e s s T O O L S t o E x i t
Enter new tool number and press the “ENTER” key again.
LINEAR
ACCELERATION
S-CURVED
ACCELERATION