PA Industries Transporter - Manual (Page 10)

10
1. Verify that the Extension, Inner Disc, and Valve Rod
must be very straight and not overtightened.
2. Assemble all components of the Piston Valve Assembly
T10-606, install in the Transporter Body, and add the
Outer Disc, noting the .015” (.38mm) movement for
proper operation.
3. If many parts have been replaced, the Transporter may
need a brief run-in period before final adjustments are
made.
8. Carefully Disassemble the Piston Valve Assembly.
9. Examine all Springs, “O” Rings, and Valve Discs for
damage and replace as necessary.
1. Remove the Guide Column Locking Nuts T10-214
and the Tray Holder Screws T10-210 for the Front
Holder T10-202.
2. Pull out the Front Holder T10-202 together with the Air
Regulator Rod and Nut T10-604 and Threaded Guide
Columns T10-203.
3. Pull out the Rear Holder T10-201 together with the
Rear Pistons T10-303.
4. Remove the Air Inlet T10-601 and O-Ring 14208-119
with an 8 mm hex wrench.
5. Remove the Nut T10-305 from the Piston T10-302.
6. Remove the disc from the Valve Rod using a Phillips
head screwdriver at the T10-325, and a 13 mm socket
at the opposite end.
7. Remove the Piston Valve Assembly T10-606.
Sample
tray
shown
Factory Repair & Rebuild Service
Return the Transporter by UPS Prepaid to our repair center.
After teardown and inspection, P/A Industries will notify you
of the recommended cost for spare parts and labor.
MODEL TP-10 SERVICE
Disassembly
Reassembly