PA Industries Precision AirFeed - Manual (Page 15)

13
SPEED CONTROL
The Speed Adjustment Screw is located on the side
opposite the air inlet. It provides material velocity
control during the feeding direction of the Feed Slide.
HOW TO SET
1. Cycle the Feed manually, turning the Speed
Adjustment Screw clockwise until the Feed motion
becomes erratic or incomplete.
2. Turn the Speed Adjustment Screw counter-clock-
wise until Feed Slide makes a complete forward motion.
3. Turn the Speed Adjustment Screw an additional
half turn counter-clockwise.
4. If the material slips forward under the Clamp upon
impact with the Main Body, turn the Speed Adjustment
Screw clockwise 1/4 turn or until slippage stops.
SAFE WORKING SPEEDS AT VARYING LENGTHS
MODELS
FX & HX
MODEL
AX
MODELS
CX & DX
MODEL
LX
CAUTION!
Never open the
Speed Adjustment
Screw more than
three complete turns.