PA Industries Precision AirFeed - Manual (Page 6)

4
MOUNTING THE AIR FEED
Its compact design will allow this Feed to be installed
on the Die or Press Bolster, or on many types of
machines, at any angle, including upside down or
vertical. Use two (or four) minimal clearance Hold-
Down Bolts to solidly fasten the Feed as close to the
Work Station as possible. NEVER use ‘C’ clamps as
the Feed may move or shift position.
The top of the Feed Wear Plate should be level with
the lower Die Face and the front of the Feed square
and centered with the tool.
CORRECT
NOT
CORRECT
A mounting
bracket provides
easy vertical
adjustment for
tools with different
stock line
heights.
The Feed can be
moved from
press to press, or
die to die, in a
matter of minutes.
Mounting directly
on the Die is
recommended
for “Just-In-Time”
production and
to reduce set-up
time.