Actiontec SBWD100A, SBT100U Installation Guide - Manual (Page 2)

Step
2
Plug one end of the power
cord into the power port on the
back of the Receiver.
Plug the other end into a nearby
electrical outlet.
Step
3
Plug one end of the HDMI
cable into the HDMI port on the
back of the Receiver.
Plug the other end into an HDMI
port on your HDTV.
Make sure your HDTV is set to the
same HDMI port to which you
connected the Receiver.
NEXT Flip this Guide over to continue
A
Install the Receiver
Welcome!
Congratulations on your purchase of a ScreenBeam Wireless
Display Kit. The Kit lets you wirelessly transmit content from your
compatible PC or Wi-Fi Miracast device to your HDTV.
Step
2
When you see the screen
shown on the right, make sure
you’ve completed the steps in
Section A of this Guide.
Then, continue to follow the
onscreen instructions.
Step
4
Insert the USB Transmitter
into a USB port on your laptop/PC,
then click Next.
Step
1
Get the ScreenBeam Receiver, power cord, and HDMI
cable from the package.
Step
1
Insert the ScreenBeam CD
into the CD drive of a laptop/PC.
An AutoPlay window appears on
the screen.
Click Run setup.exe, then follow
the onscreen instructions.
Step
3
When you see the screen
shown on the right, get the
ScreenBeam Wireless Display
USB Transmitter.
Step
5
Click in the button next to
“Yes, I want to restart my computer
now,” then click Finish.
The laptop/PC reboots.
C
Pair the Receiver and USB Transmitter
Step
1
Launch the ScreenBeam
Wireless Display application by
clicking on the ScreenBeam icon
on the Windows desktop, or locate
then launch the application from
Windows Search.
Step
2
The main ScreenBeam
screen appears. Click Add a
Receiver.
B
Install the Software and USB Transmitter
Important! If you are using a Wi-Fi Miracast or Intel Wireless Display
(WiDi) device, complete Section A, “Install the Receiver,” only. To check
for device compatibility, go the section titled “For Wi-Fi Miracast or Intel
WiDi Device” on the other side of this Guide.
Note: Use the 5V/2A power adapter provided by Actiontec (Model # WA-
10P05FU) only.
Note: If you don’t see the AutoPlay screen, locate the CD-ROM folder from
Windows Explorer, then double-click on setup.exe. If your laptop/PC does
not have a CD/DVD drive, go to www.actiontec.com/screenbeamkit
to download the ScreenBeam software.
Note: If the USB Transmitter was already connected to the laptop/PC prior
to step 4, unplug it, then plug it back in.
Note: Actiontec recommends plugging in your laptop/PC when using
ScreenBeam. If running your laptop on battery, make sure its power
settings are configured for “Maximum Performance.”
This section will guide you through the Wireless Display Software
and USB Transmitter setup. If your laptop/PC has either Intel WiDi
3.5 (or higher) or Wi-Fi Miracast (e.g., Windows 8.1 or Android
4.2), then proceed to the section of this Installation Guide titled
“For Wi-Fi Miracast or Intel WiDi Devices.”
Note: The AutoPlay window may look different, depending on the operat-
ing system version being used on the device..
Note: You may encounter a product registration screen requesting for the
software registration key. The registration key can be found on the back of
the software CD sleeve.