Actiontec SBT100U User Manual
Page 2
Welcome!
Step
2
Plug one end of the power
cord into the power port on the
back of the Receiver.
Plug the other end into a nearby
electrical outlet.
Step
3
Plug one end of the HDMI
cable into the HDMI port on the
back of the Receiver.
Plug the other end into an HDMI
port on your HDTV.
Make sure your HDTV is set to the
same HDMI port to which you
connected the Receiver.
NEXT
Flip this Guide over to continue
A
Install the Receiver
Congratulations on your purchase of a ScreenBeam Wireless
Display Kit. The Wireless Display Kit lets you wirelessly transmit
what’s on your Windows 7 or 8 laptop/PC, Miracast™ device,
or Intel® WiDi device, and display it on your HDTV.
Step
2
When you see the screen
shown on the right, make sure
you’ve completed the steps in
Section A of this Guide.
Then, continue to follow the
onscreen instructions.
Step
4
Insert the USB Transmitter
into a USB port on your laptop/PC,
then click Next.
Step
1
Get the ScreenBeam
Wireless Display Receiver, power
cord, and HDMI cable from the
Wireless Display Kit.
Step
1
Insert the ScreenBeam CD
into the CD drive of a laptop/PC.
An AutoPlay window appears on
the screen.
Click Run setup.exe, then follow
the onscreen instructions.
Step
3
When you see the screen
shown on the right, get the
ScreenBeam Wireless Display
USB Transmitter.
Step
5
Click in the button next to
“Yes, I want to restart my computer
now,” then click Finish.
The laptop/PC reboots.
C
Pair the Receiver and USB Transmitter
Step
1
After the laptop/PC
fi nishes rebooting, click the
ScreenBeam icon on the
laptop/PC desktop (circled in red).
Step
2
The main ScreenBeam
screen appears. Click Add a
Receiver.
B
Install the Software and USB Transmitter
Important Note: If you’re connecting to a device that has built-in
Miracast or WiDi (3.5 or higher), you’ll only need to complete Section
A of this Quick Start Guide. After completing the steps in Section A,
go to the end of this Guide for additional information about Miracast
and Intel WiDi devices.
Note: Only use the 5V/2A power adapter provided by Actiontec
(Model # WA-10P05FU).
Note: If you don’t see the AutoPlay screen, locate the CD-ROM folder from
Windows Explorer, then double-click on setup.exe. If your laptop/PC does
not have a CD/DVD drive, go to www.actiontec.com/screenbeam to
download the ScreenBeam software.
Note: If the USB Transmitter was already connected to the laptop/PC prior
to step 4, unplug it, then plug it back in.
Note: Actiontec recommends plugging in your laptop/PC when using
ScreenBeam. If running your laptop on battery, make sure its power
settings are confi gured for “Maximum Performance.”