Actiontec V1000H User Manual User Manual
Page 24
21
Chapter 3 Wireless Settings
To change the radio settings of the Modem Router’s wireless network (if needed;
you do not need to make all the changes in this procedure, as they can be changed
independently of each other):
Select the radio’s channel from the Channel drop-down list.
1.
Select the level of the wireless radio’s power level.
2.
Select the wireless network’s mode. Options include whatever mix of 802.11b,
3.
g, and n modes you prefer (except b/n only).
Select the channel width by clicking in either the 20 Mhz or 40 Mhz
4.
radio buttons.
If 40 Mhz was selected in step 5, select the channel’s width (
5.
Upper or Lower).
Set the MSDU (MAC-Layer Service Data Unit) aggregation state by clicking
6.
in the Enable or Disable radio buttons below step 6. MDSU should only be
enabled/disabled by an experienced network technician.
Set the MPDU (MAC-Layer Protocol Data Unit) aggregation state by clicking
7.
in the Enable or Disable radio buttons below step 7. MPDU should only be
enabled/disabled by an experienced network technician.
Click
8.
Apply.