Carolina NeuLog UVB User Manual
Neulog uvb sensor guide
NEULOG UVB SENSOR GUIDE
NeuLog UVB sensor
NUL-230
The NeuLog UVB sensor can be used for any science experiments or activities which
utilize accurate UVB readings such as in the fields of: Environmental Science, Biology,
Physiology, Chemistry, Weather Science, etc.
The sensor comes pre-calibrated so you can start experimentation right out of the box
using any of the following guides.
UVB (Ultraviolet B) rays are a type of electromagnetic radiation which have a
wavelength shorter than visible light in the range between 320 and 280 nanometers.
Ab
out 2% of UV rays that reach earth’s surface are UVB and they are attributed with
skin cancer by directly damaging DNA.
Just a few of the thousands of possible experimental subjects that can be done with
the NUL-230 sensors are: UVB levels in different weather conditions, UVB levels
against altitude, weather patterns, plant growth studies, small animal behavior
experiments, light emitting chemical reactions, and many more.
The UVB sensor uses the following units of measure:
Milli Watt per square meter (mW/m
2
): A measurement of power density.
The amount of watts per square meter.
Quick start procedure:
PC or Mac Computer
Materials needed:
A USB to mini USB cable (which comes with the USB-200)
Your UVB sensor needs to be connected to a USB-200 module. The USB-200
module then connects to a computer via a USB to mini-USB cable. Please note that
you cannot plug the UVB sensor directly into the computer.
Resident PC software and browser based software can be downloaded for free at
www.NeuLog.com/dowload as well as a full software user guide. Note: Make sure not
to download and install both types of software, they will conflict on the computer.
Procedure:
1.
Install the NeuLog software
2.
Connect the USB-200 module to the PC or Mac
3.
Connect the UVB sensor to the USB-200 module (they directly plug
together). Please note there is no calibration required for this sensor.
4.
Open the NeuLog software.
5.
Once a UVB sensor logo appears on the left side of the screen the probe
has been automatically identified and you can begin experimentation.
6.
If the UVB sensor is not automatically
identified then click the “Search for
sensors” icon to find the sensor.
7.
Select the “On-line experiment” button; this will open a graph below.
8.
Click on the “Module setup” button located on the UVB sensor icon in the
module window to change the sensor settings if need be.
9.
Click on the experiment set up button to change the experiment settings if
need be (experiment duration for example).
10. The UVB sensor will give a live reading in the box to the left of the screen
while plugged in.
11. To run an experiment and col
lect data click “Run experiment”.
12.
To end data collection early, click “Stop experiment”.
Tablet, smart phone device
Materials needed: