Castle TSM-21 Serial 61076 to 64233 (Parker) Operator Manual - Manual (Page 14)

ƒ Inspect the pocket. If the drilled hole is off center (Figure 6), it can be centered using the
adjusting nut on the Pilot Hole Adjustment Bolt just below the drill motor. (Figure 7)
Figure 6 Figure 7
ƒ Tightening the nut moves the drill tip left relative to the operator. Adjust accordingly.
ƒ The Router Feed rate can be adjusted by using the flow control knob next to the air
supply port (Refer to the Adjustment chapter on page 14). Turning it clockwise will
reduce Router Feed rate, and turning it counter-clockwise will increase it. If the feed rate
is too slow it can cause burning of the bit and burning of the pocket. If the rate is too fast
it can cause the wood to shift.
ƒ Turn the Power Switch off when initial configuration is complete.
12