Alpine 68-00493Z15-B - Manual (Page 17)

FR
ES
DE
SE
IT
15
-EN
Installation
Installing AV Interface Unit
This Unit can be placed inside the trunk, on the
kick panel of the front passenger's seat or
underdash. However, to avoid unnecessary
signal wiring, it is better to mount the Unit as
close as possible to the Display.
DO NOT MOUNT THE INTERFACE UNIT IN
LOCATIONS EXPOSED TO MOISTURE OR
EXTREME HEAT (such as the engine
compartment).
Velcro fastener Mounting:
1. Place a Velcro fastener onto the mounting
surface. The rough side should be facing the unit.
2. Remove the backing to the adhesive on the
Velcro strips. Press the unit onto the mounting
location.
TOUCH PANEL WIDE LCD MONITOR
■ POWER SUPPLY
■ RGB IN
■ PHONE OUT
■ DISPLY OUT
■ AUX OUT
■ AUX IN 2
■ AUX IN 1
VIDEO
AUDIO L
R
VIDEO
AUDIO L
R
VIDEO
AUDIO L
R
TME-M770
Velcro fastener
(included)
TOUCH PANEL WIDE LCD MONITOR
■ POWER SUPPLY
■ RGB IN
■ PHONE OUT
■ DISPLY OUT
■ AUX OUT
■ AUX IN 2
■ AUX IN 1
VIDEO
AUDIO L
R
VIDEO
AUDIO L
R
VIDEO
AUDIO L
R
TME-M770
Attaching with screws
1. Place the unit on the location chosen for installa-
tion.
2. Mark the screw locations using the unit as a
template.
3. Drill a hole less than 3 mm in diameter.
WARNING
When you are drilling a hole in the car body,
be careful not to damage pipes, tanks or
electrical wiring etc.. It might cause an acci-
dent or a fire.
4. Firmly attach the unit using 4 of the supplied self-
tapping screws (M4 x 14).
Self-tapping screws (M4 x 14)