Castle TSM-11 - Manual (Page 17)

CASTLE, INC TSM‐11 OWNERS MANUAL V1.4 Page 17 of 22
5.2 Web Adjustment
To move the pocket (routed portion) closer to, or further from, the edge of the material, use a
7/16” wrench and loosen the Nylock nut next to the operating
handle. Moving the nut away from you will make the pocket
cut closer to the edge of the material, pulling the nut toward
you will make the pocket farther from the edge of the material.
Tighten the nut each time before testing. This is a trial and
error method until you get the pocket where it suits you best.
5.3 Adjusting for Thinner Material
Your TSM-11 is set up for use in ¾” material. It can be adjusted to work in 5/8” or ½” material.
To do so, make a shim the size of the work top from 1/8” or ¼” plywood material. Lay it on the
work table then place your stock on the shim material. Adjust the clamp hold down arm if
necessary and rout through both pieces. When finished processing your thinner material,
remove the shim material and readjust the clamp if necessary. You are again ready for your
regular thickness material.
Fig 29