Never use flame – NewAir APH-4000PV User Manual

Page 4

Advertising
background image

4


operating instructions. If any time gas odor is detected, shot off the
appliance immediately, find and correct the leak. Please set up the propane
supply with utmost care.

 

Alert both children and elders to the hazard of high surface emperatures.

Care must be taken for the supervision of children in the vicinity of an
operating or hot heater.

 

Your children and pets should be supervised when they are in area of

heater.

 

This outdoor patio heater must be used for outdoors only in a well

ventilated area and not be used in a vehicle or any enclosed building.

 

Always place the heater on a level stable surface.

 

Do not move, touch the heater while hot or burning.

 

Do not alter or modify the heater in any manner

 

Use only a U.S. Department of Transportation approved 20 pound

standard cylinder equipped with an TYPE 1 connection with QCC
(Quick Connect Coupler).

 

Use only with propane / LP Gas. Do not attempt to use any other fuel.

 

Always keep at least a 24 ‘’ clearance from any combustible material.

 

Do not use if the wind velocity is greater than 10 miles/hr.

 

Do not use if the environment temperature is below 40 F.

 

Do not spray aerosols near the heater while in use.

 

Do not clean heater with combustible or corrosive cleaners. Use warm, soapy

water.

 

Do not hang clothing or flammable materials either on or near heater

 

Do not move, touch the heater while it is hot or in operation.

 

Place the control knob on OFF position when heater is not in use and always

disconnect the gas cylinder at its main valve and store it outdoors where it is
not accessible to children. Never store a propane cylinder indoors

 

Always 45 minutes to cool down after use before attempting to move your

heater.

 

Use only the hose and regulator with the heater provided by the factory. Check

the regulator and hose assembly before each use. If you find an excessive
abrasion or hose is cut, please replace with the Regulator assembly listed on
the parts list right away.

 

Never use the heater if the ballast weight is not assembled into the base. The

base must be weighted to prevent possible tipping.

 

Inspect heater before each use and inspect annually by a qualified service

person. Do not operate a damaged heater.

 

Leak check only with soapy water when the initial assembly and after every

cylinder is replaced. All gas connections should be checked. Look for bubbles.

Never use flame!


Warning:
When the heater is to be operated in the presence of other people, the user is

Advertising