Hunter 22555 10 Opal Glass Schoolhouse Globe - Manual (Page 5)

Installing the Light Kit on Fans With Non-Removable Switch Housing
and No Center Hole
1. Uninstall the two screws from the switch housing.
2. Remove the wire nuts from the two wires in the switch housing labeled
“Connect Light Here” or “For Light Use.” One wire is white and the other wire is
black/white striped.
Connect the black/white striped wire from the switch housing to the black wire from
the light kit. Connect the white wire from the switch housing to the white wire from
the light kit. Secure all wire connections using wire nuts.
To connect the wires, hold the bare metal leads together and place a wire nut over
them, then twist the wire nut clockwise until tight.
CAUTION: Be sure no bare metal wires or wire strands are visible after making
the connections.
3. Finish attaching the light kit to the switch housing. Use the two screws removed
from the switch housing and the lock washers on the red tag. Partially install the
screws into the light kit and the housing. Rotate the light fixture clockwise until the
screws are locked into the narrow ends of the keyhole slots. Securely tighten the two
screws.
WARNING: Improper installation could cause the light fixture to fall, or result
in electrical shock or personal injury.
4. Go to the instructions for Installing the Bulbs, Chains, and Globe.
O I
Step 1 Step 2 Step 3
Hunter original and non-
removable switch, no center hole
Switch
Housing
Plate
Wires and
Wire Nuts
Screw
43506-01 r032907 
Light Kit
Mounting Plate
Screws
and
Washers