CEMB USA C73 (A) - Manual (Page 7)

I 0567 - 7
5
GB
4 - CONTROLS AND COMPONENTS
4.1 - Brake pedal ►
This pedal allows the operator to hold the
wheel when fi tting the counterweights.
It
must not be actuated during the mea-
suring cycle.
4.2 - Automatic distance and diameter gauge
This gauge allows measurement of the distance of the wheel from the machine and the wheel diameter at the point of
application of the counterweight. It also allows correct positioning of the counterweights on the inside rim by using the
specifi c function (see
INDICATION OF EXACT CORRECTION WEIGHT POSITION ) which allows reading, on the monitor,
the position used for the measurement within the rim (for calibration, see the corresponding section).
4.3 - Automatic width gauge (optional)
Width gauging is through a SONAR device which measures the distance of the wheel without mechanical contact,
merely by closing the guard and each time a valid measurement has been made with gauge
AUTOMATIC DISTANCE
AND DIAMETER GAUGE .
4.4 - Automatic wheel positioning
At the end of the spin, the wheel is positioned according to the unbalance on the outside or else according to the static
unbalance (when selected).
Accuracy is ± 20 degrees.
4.5 - Keyboard
►
►
►
►
N.B.: Press the buttons with the fi ngers only: never use the counterweight pincers or other
pointed objects.
When the beep signal is enabled (see section ACOUSTIC SIGNAL ), pressing of any push
button is accompanied by a “beep”.
The TFT monitor is NOT a TOUCH SCREEN type.
FUNCTION KEYS: they directly select the function on screen
Starts measuring
cycle
Selection of special
function
Confi rm Stops machine
cycle