1 - using the extension for the distance gauge – CEMB USA K22 (A) User Manual
Page 14
Advertising
I 0310 -
14
I 0574
- 14
6
7
GB
-
6.3 - Manual dimension presetting (Use only in particular cases or for test)
- Set the distance “a” of the barycentre of the inside correction
weight
- It is essential that you determine and set accurately the distance
‘b’ between the barycentres of the weights where they will be
applied.
- Set the nominal diameter ‘d’ as shown on the tyre.
6.3.1 - Using the extension for the distance gauge
▪ Fit the extension on the distance gauge
▪ Proceed with measuring the distance as described in Fig. 7
▪ Having read value “a” on the dial, reset the gauge to “0” and manually set the value “a + 100 mm“
▪ Manually set the diameter and the width, as already described.
Extension
Reading point
Reading point
Advertising