CHIEF RPMA1-B1-C1 User Manual
Page 6
RPMA1, -B1, -C1
Installation Instructions
6
2.
Remove the paper backing from the adhesive washers (V)
and attach projector to RPMA1 bottom using adhesive
washers (V) and thumbnuts (P) over the security legs (R).
(See Figure 5)
Figure 5
NOTE:
An optional SLB bracket may be purchased and used
to attach projector to RPMA1. (See Figure 5)
3.
Attach RPMA1 bottom to RPMA1 top using four Phillips
screws removed in Step 5 of Installing Ceiling Plate and
Disassembling RPMA1. (See Figure 6)
Figure 6
Figure 7
4.
Move locking lever to "Locked" position. (See Figure 7)
5.
Insert key into lock and turn to secure projector to mount.
(See Figure 7)
Attaching RPMA1 to Threaded Pipe
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
PROJECTOR FALLING RESULTING IN SERIOUS
PERSONAL INJURY OR DAMAGE TO EQUIPMENT. DO
NOT substitute hardware. Use only the hardware provided by
the manufacturer.
1.
Align RPMA1 with end of NTP pipe. (See Figure 8)
2.
Thread RPMA1 up onto pipe by turning counterclockwise
until hand tight. (See Figure 8)
Figure 8
(P) x 4
(V) x 4
Security
Legs (R)
Projector
RPMA1
Bottom
Attachment areas if using an
optional SLB bracket.
x 4
3
4
5
1
2