CHIEF RPMA1-B1-C1 - Manual (Page 7)

Installation Instructions RPMA1, -B1, -C1
7
Rough Alignment of RPMA1
1. Turn RPMA1 clockwise or counterclockwise until the front of
the RPMA1 and projector is facing target. (See Figure 9)
Figure 9
2. Secure set screw and security Phillips screw under set
screw. (See Figure 9)
Adjustments
The RPMA1 can be adjusted for rotation (yaw), vertical
elevation (pitch), and horizontal tilt (roll).
Figure 10
YAW Adjustment
1. Loosen YAW adjustment locking screw using a #2 Phillips
screwdriver. (See Figure 10)
2. Turn YAW micro-adjustment screw right or left using a #2
Phillips screwdriver until image is properly aligned on target.
3. Tighten YAW adjustment locking screw using a #2 Phillips
screwdriver.
PITCH Adjustment
1. Loosen PITCH adjustment locking screw using a #2 Phillips
screwdriver. (See Figure 11)
2. Turn PITCH micro-adjustment screw right or left using a #2
Phillips screwdriver until image is properly aligned on target.
3. Tighten PITCH adjustment locking screw using a #2 Phillips
screwdriver.
Figure 11
ROLL Adjustment
1. Loosen ROLL adjustment locking screw using a #2 Phillips
screwdriver. (See Figure 12)
2. Turn ROLL micro-adjustment screw right or left using a #2
Phillips screwdriver until image is properly aligned on target.
3. Tighten ROLL adjustment locking screw using a #2 Phillips
screwdriver.
Figure 12
1
Secure set screw,
then Phillips screw
from under set screw.
2
1
3
2
1
2
3
2
1
3