CHIEF FSP Series - Manual (Page 5)

Installation Instructions FSP Series
5
INSTALLATION
WARNING: Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! It is the installer’s responsibility to
make sure the structure to which this component is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component.
IMPORTANT ! : These instructions assume that a 1-1/2"
to 2" O.D. pipe (not included) has been properly installed
in either a vertical or horizontal position.
(Optional) Latching Flag Placement
The latching flag may be moved as necessary.
1. Remove Phillips undercut machine screw, spacer, Nylock
nut and latching flag from FSP (A). (See Figure 1)
Figure 1
2. Re-position latching flag and tighten using Phillips undercut
machine screw, washer and Nylock nut.
FSP Mount Assembly and Installation
The FSP includes tilt bracket that can be repositioned to attach
to a vertical or horizontal pipe. The FSP assembly ships
configured for vertical pole mounting. To change the FSP for
horizontal pole mounting, use the following instructions. To use
the FSP in the vertical configuration, proceed to Vertical
Installation section.
Horizontal Installation
1. Remove the four Phillips pan head tapping screws from
FSP assembly (A). (See Figure 2)
2. Detach tilt bracket from FSP (A). (See Figure 2)
3. Reposition tilt bracket for horizontal pipe/pole mounting.
(See Figure 2)
Figure 2
1
(A)
Latching flag
Nylock nut
Spacer
1
(A)
2
(Tilt bracket
adjusted for
horizontal
pipe mount)
3
x 4