CHIEF FSP Series - Manual (Page 7)

Installation Instructions FSP Series
7
Installing Display with Interface Bracket
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components attached to the FSP does not exceed 45 lbs
(20.4 kg).
1. Install FSB interface bracket (E) to display using the
instructions and hardware provided with the interface
bracket kit.
2. Make sure latching flag on FSP mount (A) is in the unlocked
position. (See Figure 7)
Figure 7
3. Lift and maneuver display with attached FSB bracket (E) so
that mounting buttons on interface bracket fit into button
openings on FSP (A). (See Figure 8)
Figure 8
4. Engage FSP latching flag, locking display in place (See
Figure 8).
Tilt Adjustment
WARNING: IMPROPER HANDLING CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Inadequate support
of display while adjusting tilt may cause display to fall!
5. Adjust tilt by loosening (slightly) tilt adjustment screws on
each side of FSP (A), adjust to desired angle, and tighten tilt
adjustment screws. (See Figure 9)
Figure 9
Unlocked
(A)
2
(E)
Unlocked
3
(A)
Locked
4
Display
Display
5
(E)
(B) x 4
(A)