CHIEF SSBU-SSMU Interface - Manual (Page 7)

Installation Instructions SSBU/SSMU
7
4. Place SSBU/SSMU legs (C) over screw adapters and
height-adjustment nuts. (See Figure 4)
NOTE: Make sure arm latch clips are in the unlocked position.
Figure 4
5. Press locking buttons on SSBU/SSMU leg (C) firmly and
simultaneously push clip cover away from enclosed sliding
stud mount bracket until clip cover is in the locked position.
(See Figure 5)
6. Repeat Step 5 for remaining legs.
WARNING: Make sure legs have securely locked onto
height-adjustable nuts with the latch clips. If the legs are not
properly locked onto the adapters, the projector could fall
from the SSBU/SSMU mount causing SERIOUS INJURY or
DEATH!
Figure 5
7. Maneuver legs so that sliding stud mount brackets and
screws are towards the middle of the projector. (See
Figure 6) and (See Figure 7)
8. Position sliding stud mount brackets and screws so that
SSBU or SSMU main plate (A) can be evenly mounted to
legs. (See Figure 6) and (See Figure 7)
9. Secure SSBU/SSMU main plate to SSBU/SSMU legs by
installing 1/4-20" Allen nuts (S) to screws on SSBU/SSMU
legs. (See Figure 6) and (See Figure 7)
NOTE: The following examples are two of many possible
scenarios based on typical examples of mounting hole
patterns. Specific connection points will vary based on
the hole pattern. Multiple scenarios may be used for
each specific hole pattern as long as the weight of the
projector is centered and balanced after mounting.
Figure 6
Figure 7
(C) x 3 or 4
open position
locked position
5
locking buttons
Three-hole scenario example
(S) x 3 9
(A)
sliding stud mount
brackets and
screws
9
Four-hole scenario example
(A)
(S) x 4
sliding stud mount
brackets and
screws