CHIEF MFC Series - Manual (Page 7)

Installation Instructions MFC Series
7
IMPORTANT ! : When attaching head assembly ensure
that the ClickConnect lock is at TOP of head assembly,
and bracket tabs slide into the stand assembly. (See
Figure 5)
1. Slide head assembly (G) into the stand assembly. (See
Figure 5)
2. Attach head assembly (G) to the cart assembly using four
5/16-18 x 3/4" button head cap screws (K). (See Figure 5)
Figure 5
Adjusting Cart Height
CAUTION: ALWAYS remove the display(s) BEFORE
adjusting the height of cart.
1. Firmly grasp head assembly. (See Figure 6)
IMPORTANT ! : To avoid pinching hands, hold head
assembly when adjusting cart height.
Figure 6
2. Adjust the cart to the desired height by slightly lifting the
head assembly, pulling out knob on the center post and
turning 90
o
in either direction to disengage the locking
mechanism. (See Figure 7)
3. Raise or lower the center post, then turn the knob 90 o either
direction to engage the knob and lock the cart at desired
height. (See Figure 7)
Figure 7
IMPORTANT ! : Set the height of the cart so the display
does NOT rest on the lower part of the center post.
(See Figure 7) Always set the height so the knob is
engaged in a hole in the center post.
ClickConnect
lock at TOP of
head assembly
2 (K) x 4
(G)
1
Bracket Tabs
Grasp head assembly
within shaded area.
Do NOT let
display rest
here
2
3
Inner
Column