CHIEF MFC Series - Manual (Page 8)

MFC Series Installation Instructions
8
Attaching Display to Cart
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components located between the MFC Series cart up to
(and including) the display does not exceed 125 lbs
(56.70 kg) for the MFC Series. Use with heavier televisions
may result in instability causing tip over resulting in death or
serious injury!
CAUTION: Before attaching display to cart set the brakes
on the back wheels by pressing down on the tab. (See
Figure 8)
Figure 8
1. Attach MSBU interface bracket to the display following the
instructions included with the MSBU interface bracket.
2. While supporting both sides of display, align four mounting
buttons on interface bracket with four mounting holes in
head assembly. (See Figure 9) and (See Figure 10)
Figure 9
WARNING: Display may be very heavy! Ensure display
may be safely lifted and maneuvered as required to install on
cart. Failure to take adequate precautions may result in
serious personal injury or damage to equipment!
3. Lower display into place listening for audible "click" to
ensure recessed area of mounting buttons are properly
seated in lower area of mounting holes. (See Figure 9) and
(See Figure 10)
WARNING: IMPROPER INSTALLATION CAN LEAD TO
CART OR DISPLAY FALLING CAUSING SERIOUS
PERSONAL INJURY OR DAMAGE TO EQUIPMENT!
Ensure mounting buttons are completely engaged in
mounting holes.
NOTE: Holes are provided in the faceplate for use with a
padlock or similar locking device, if desired. In addition,
the pin and nut may be removed from the upper holes
and moved to the lower holes for use as a more
permanent locking device. (See Figure 10)
Figure 10
Press down to
set brakes
2
3
2
3
May remove
pin and nut and
move to lower holes
A padlock or bolt
may be placed
through latch holes