CHIEF FSRI2T - Manual (Page 4)

FSRI2T Installation Instructions
4
ASSEMBLY AND INSTALLATION
NOTE: The FSRI2T is compatible with the iPad® 2 and iPad® 3
mobile digital device models alone, not mounted in a
case.
Assembly
1. Assemble two side assemblies (A) to two end assemblies
(B). (See Figure 1)
2. Fasten side and end assemblies together using four
06-32 x 1/4" buttonhead security screws (F). (See Figure 1)
Figure 1
Installation
NOTE: The FSRI2T mounts directly to a drywall (1/2" minimum
thickness) or concrete wall.
Installing to Drywall (1/2" thick minimum)
1. Determine mounting location on wall, ensuring that holes
will be drilled into drywall, not into wood studs.
2. Using FSRI2T as a template, level and mark four holes at
the four holes in FSRI2T. (See Figure 2)
3. Drill four 1/2" pilot holes at marked locations on wall. (See
Figure 2)
Figure 2
4. Hold metal channel on 1/4-20 toggler anchor (E) flat
alongside plastic straps and slide channel through pilot hole.
(See Figure 3)
Figure 3
5. Holding plastic straps on anchor, pull anchor away from wall
until channel rests flush behind wall making sure anchor
channel is positioned vertically behind drywall. (See Figure 4)
6. Slide plastic cap on anchor towards wall until flange of cap
is flush with wall. (See Figure 4)
Figure 4
(A)
(B)
(F) x 4 2
(A)
(B) 2
3
x 4
(E) x 4
Drywall
Plastic Straps
4
(E) x 4
Plastic Cap
Drywall
Anchor Metal Channel
6
5
(side view)