CHIEF NS1F12-20-28-36-41 - Manual (Page 6)

NS1F12-20-28-36-41 Installation Instructions
6
Attaching Optional Side Panels, Optional Doors
IMPORTANT ! : If installing doors (not included) and side
panels (not included) on an S1 rack, the doors must be
installed before installing the side panels.
1. If desired, add optional door(s) (not included) to the rack
following instructions included with the door(s).
IMPORTANT ! : If the door(s) are to be attached with the
pull-ring handle on the right side, the grounding screw,
washer and wire already installed on the door must be
removed and reinstalled on the opposite end of the door
before the door is installed. See instructions included
with the door(s).
2. If desired, add optional side panels (not included) to the
rack following instructions included with the panel(s).
NOTE: If NOT adding door(s), proceed to Step 4 of
Completing Installation section.
Figure 6
Figure 7
DANGER: IMPROPER WIRING CAN LEAD TO DEATH
OR SEVERE PERSONAL INJURY! Grounding must be
installed by qualified personnel using a UL Recognized No.
12AWG Green and Yellow grounding wire connected to
grounding lug on rack.
(front view of rack)
Grounding screw and nut
installed at factory
affixed adjacent to grounding terminal.
Earthing symbol IEC 60417 No. 5019
Locations of
grounding lugs