CHIEF PAC715 - Manual (Page 6)

PAC715 Installation Instructions
6
Camera Mounting
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all equipment and accessories mounted on the PAC715 does
not exceed 10 lbs (4.54 kg).
NOTE: Mounting options will vary depending on the type of
camera being mounted.
1. Install 1/4-20 x 3/8" Phillips pan machine screw (F) through
holes on shelf and into hole on bottom of camera. (See
Figure 3)
NOTE: Camera can be secured to mount by threading a tie
through outside slots on camera mount and around the
camera.
NOTE: It is also acceptable to mount the camera directly to the
shelf without any screws or ties.
Adjustments
Height Adjustment
1. Loosen two adjustment knobs on the back of the video
conferencing shelf (A). (See Figure 4)
2. Raise or lower shelf to desired height. (See Figure 4)
3. Tighten two adjustment knobs on the back of the shelf until
mount is secure. (See Figure 4)
Figure 4
Shelf Extension Adjustment
1. Loosen two button head cap screws on video conferencing
shelf (A). (See Figure 5)
2. Adjust shelf to desired mounting position. (See Figure 5)
3. Tighten two button head cap screws on shelf until mount is
secure. (See Figure 5)
Figure 5
camera (example)
(F) 1
1 2 3
1 2 3