AAON SA-070 - Manual (Page 16)

16
General Information
SA Series self contained units and indoor air
handling units have been designed for
indoor installation only. SA Series units can
contain
spring isolated direct drive
backward curved plenum fans, shell and
tube
or brazed plate water-cooled
condensers, R-410A scroll compressors,
evaporator coils, chilled water cooling coils,
steam or hot water heating coils, waterside
economizers, and a single point power
connection. Units are assembled, wired,
charged and run-tested at the factory. SA
Series units are not intended for residential
use.
Codes and Ordinances
SA Series units have been tested and
certified, by ETL, in accordance with UL
Safety Standard 1995/CSA C22.2 No. 236.
System should be sized in accordance with
the
American Society of Heating,
Refrigeration and Air Conditioning
Engineers Handbook.
Installation of units must conform to the
ICC
standards of the International
Mechanical Code, the International Building
Code, Installation of Air Conditioning and
Ventilating Systems Standard, NFPA 90A,
and local building, plumbing and waste
water codes. All appliances must be
electrically grounded in accordance with
local codes, or in the absence of local codes,
the
current National Electric Code,
ANSI/NFPA 70 or the current Canadian
Electrical Code CSA C22.1.
Receiving Unit
When received, the unit should be checked
for damage that might have occurred in
transit. If damage is found it should be noted
on the carrier’s Freight Bill. A request for
inspection by carrier’s agent should be made
in writing at once.
Nameplate should be checked to ensure the
correct model sizes and voltages have been
received to match the job requirements.
Improper installation, adjustment,
alteration, service or maintenance
can
cause property damage,
personal injury or loss of life. Startup
and service must be performed by a
Factory Trained Service Technician.
A copy of this IOM should be kept
with the unit.
WARNING
The Clean Air Act of 1990 bans the
intentional venting of refrigerant as of
July 1, 1992. Approved methods of
recovery, recycling, or reclaiming
must be followed.
CAUTION
Coils and sheet metal surfaces
present sharp edges and care must
be
taken when working with
equipment.
WARNING
Failure to observe the following
instructions will result in premature
failure of your system and possible
voiding of the warranty.
WARNING