Alpine DVI-9990 - Manual (Page 7)

6
-EN
Remove the Detachable Front Panel (refer to page 9 of Owner’s Manual). Remove the front
frame from main unit (see “Removal” on page 7).
Slide the mounting sleeve into the dashboard.
Reinforce the head unit with the metal mounting strap (not supplied). Secure the ground lead of
the unit to a clean metal spot using a screw (
★) already attached to the vehicle’s chassis.
NOTE
For the screw marked
★★, use an appropriate screw for the chosen mounting location.
Connect each input lead coming from the product you are connecting with to the correspond-
ing output lead coming from the left rear of the DVI-9990. Connect all other leads of the DVI-
9990 according to details described in the “Connections” section.
Installation
1
2
Mounting Sleeve (Included)
Dashboard
DVI-9990
Hex Nut (M5)
Screw
Bolt Stud
Metal Mounting
Strap
Ground Lead
Chassis
★★
★
DVI-9990
Installation Location
Before deciding on the mounting location, check that opening and closing the display will not
hamper gear shifting in that position.
• Install at an angle of within 35 degrees from the horizontal.