AmpliVox S1297 - Manual (Page 4)

4
LINE IN JACK :
(1/4")
CONTROL / BACK PANEL
POWER SWITCH
WIRELESS SPEAKER
16 CHANNEL RECEIVER
AUTO SWITCHING 110 / 220
VAC INPUT WITH BUILT-IN
LINE FUSE HOLDER
BATTERY STATUS LED
BATTERY PANEL
User Accessible
INDICATOR LIGHT
Charging or AC power
25 AMP CIRCUIT BREAKER
POWER SWITCH:
When power switch is in the ON position, the
BATTERY STATUS LED will be illuminated. The color of the LED
indicates the condition of the battery.
Green – battery fully charged; Flashing Green – charging
Yellow – battery low, recharge immediately
Red – battery must be recharged before use
To charge the batteries, connect the unit to 110-220VAC using the
supplied power cord. The red
CHARGE/AC ON LED will be illumi-
nated indicating battery is charging. The batteries will charge when
unit is operating with AC power,
HOWEVER the unit will charge
faster with the power switch in the “off” position.
THE S1297 MUST BE PLUGGED IN AND CHARGING WHEN NOT
IN USE TO MAXIMIZE BATTERY LIFE. RECHARGING THE UNIT
ONLY WHEN THE BATTERY STATUS LED IS ORANGE OR RED
WILL SHORTEN THE USEFUL LIFE OF THE BATTERIES.
FUSES:
There are two circuit protection devices that are
user serviceable. The 25A circuit breaker protects the power
supply and battery circuits. Press to reset. There is also a fuse
in the AC jack. It is identified on the plastic with a drawing of a
fuse.
Detach the AC cord from the unit before replacement
This fuse protects the AC circuitry. Use a flat blade screwdriver
in the slot on the top of fuse holder to slide the fuse holder out.
Replace the fuse with a 10A/250V fuse if needed.
If after resetting and replacing the breaker and fuse , the
S1297 does not “power on”, please call AmpliVox Customer
Service at 800-267-5486.
WARNING! RISK OF SHOCK! DO NOT OPEN UNIT. NO
USER SERVICEABLE PARTS INSIDE!
OPERATION
VOLUME CONTROL
WIRELESS UHF RECEIVER
ANTENNA - Screw on